Final part of the Toilet Build. I finished the toilet cabinet and installed the separating toilet. Some is still missing, such as the drawer front and toilet front panel. Those will be installed at the end of the van build. Another missing part is the connection to the gray water tank; that part of the… Continue reading DIY Separating Toilet
Finishing up the shower in a drawer with one last layer of Poly-Urethane before I go on my trip to the RTR in Quarzsite, Arizona.
Watch all my videos on YouTube! Building kitchen cabinets and fitting them in the van. Finding out if it all works or that I have to make adjustments in the design. First time inside the van standing in the shower pan, calculating where the shower head
Watch all my videos on YouTube! Now that the Murphy bed is installed, I continue with the kitchen area. It’s basically one cabinet, flanked by two narrow sliders. It will hold the sink, water heater and ‘Shower-in-a-Drawer’. Because it’s only a small cabinet and to
After the installation of the Murphy bed, I started working on the rear kitchen of the van. The bottom drawer will contain the shower pan that I constructed some time ago. Watch my upcoming video.
Watch all my videos on YouTube! The inside and outside of the shower drawer are getting three coats of polyurethane, the top of the box is finished off with a Maple edge. And when the cabinets are built, I have a novel solution for the shower head.
Watch all my videos on YouTube! I’m creating an access point to the drain, shorten the drain so it fits in the drawer cabinet and install a drain connector. The latter connects to a water hose that drains outside or it can be connected to a drain line under the cabinets, that drains into the… Continue reading Shower-In-A-Drawer – Part Three
Watch all my videos on YouTube! The shower pan fits inside a bottom drawer of one of the cabinets in the RV. This week I put the box together and cut the shower pan to size.
Watch all my videos on YouTube!